(Optional) Transmitter Programming - Genie GCL-GH Installation Manual

(Optional) Transmitter Programming

Adding a Transmitter
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL (up or down) until display reads "LEARN NEW XMTR? "
SCROLL
Figure 11.
• This question along with the instruction "HIT SET FOR YES" will
continuously pan across the display window. (Pressing SCROLL or
RUN/CAL will cancel the operation.)
SET
3) Press SET .
CLEAR
• Display will read "PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR."
4) Press Transmitter button two times.
• The display will read "XMTR ___LEARNED." Where it assigns a random
number between 1 and 50 to the transmitter. That transmitter is
entered and ready to operate the door. (Label/mark the transmitter.)
5) Press SCROLL (up or down) to move on to another menu item,
SCROLL
or CAL/RUN to exit the CAL mode.
CAL
RUN
Removing Individual Transmitter
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL (up or down) until display reads "REMOVE XMTR? "
CROL
Figure 12.
• This question along with the instruction "HIT SET FOR YES" will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
AL
SET
3) Press SET .
UN
CLEAR
• A menu displaying the available transmitter numbers will appear.
Press SCROLL (up or down) to cycle through the menu to the
SCROLL
number of the transmitter to be removed. (Pressing CAL/RUN will
cancel the operation.)
4) Press SET SET .
CLEAR
• The transmitter is removed.
5) Press SCROLL SCROLL (up or down) to move on to another menu item,
CAL
or CAL/RUN to exit the CAL mode.
RUN
GCL-GH
Heavy Duty Operator
CAL to enter calibration mode.
RUN
CAL
to enter calibration mode.
RUN
www.geniecompany.com
LEARN NEW XMTR?
CAL
Figure 11
REMOVE XMTR?
CAL
Figure 12
REMOVE ALL XMTRS?
CAL
Figure 13
Removing All Transmitters
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL (up or down) until display reads "REMOVE ALL XMTRS"
RUN
SCROLL
Figure 13.
• This question along with the instruction "HIT SET FOR YES" will
continuously pan across the display window. (Pressing SCROLL or
CAL/RUN will cancel the operation.)
SET
3) Press the SET key.
CLEAR
C OLL
• The display will read "ARE YOU SURE."
UN
4) Press the SET SET key.
CLEAR
• All transmitters are removed.
5) Press SCROLL CROLL (up or down) to move on to another menu item,
or CAL/RUN to exit the cal mode.
CAL
RUN
CLOSE
STOP
SET
CLOSE
STOP
SET
CLOSE
STOP
SET
to enter calibration mode.
CAL
RUN
03-12
6.7