Table of Contents
Advertisement
A
Errors and troubleshooting
Command Line Interface errors
These errors may occur while using the menu-based Command Line Interface from a console or Telnet
session.
ERROR:-- Bad IP Address/Subnet Mask/Wildcard Mask/Area ID.
Problem
The system expected a valid
4-byte dotted decimal entry,
and the entry wasn't in that
format.
ERROR:-- Out of Range value entered. Try again.
Problem
The system expected a number
within a certain range, and the
entry was outside that range.
ERROR:-- The Passwords do not match. Please try again.
Problem
The entry for a password and
the entry to verify the password
do not match.
A-8
Possible cause
• You entered something other
than a 4-byte dotted decimal
number. You may have
omitted a byte position, or
entered a number greater
than 255 in a byte position.
• You entered 0.0.0.0
instead of an appropriate
address.
Possible cause
• You entered a letter instead
of a number.
• You entered a number greater
than the possible menu
numbers.
Possible cause
• You mistyped an entry.
• You entered either a
password or verify entry, but
not the other.
Solution
At the prompt, re-enter a valid
4-byte dotted decimal number.
Solution
At the prompt, re-enter a
number in the appropriate
range.
Solution
At the Verify prompt,
re-enter the password. If the
original password is incorrect,
press Enter and re-enter both
the password and the
verification at the prompts.
VPN 3000 Concentrator Series User Guide
Hide quick links:
Advertisement
Table of Contents
