Configuration > Interface Configuration; Or 1.1.3 Configuration > Interface Configuration > Configure Ethernet #1 Or #2 Or #3; Configuration > Interface Configuration > Configure Power Supplies - Cisco VPN 3000 User Manual

1.1 Configuration > Interface Configuration
Model
3015–3080 only
Model 3005 only
1.1.1, 1.1.2, or 1.1.3 Configuration > Interface Configuration > Configure Ethernet #1 or #2 or #3
Only 1.1.1 and 1.1.2
on Model 3005
1.1.4 Configuration > Interface Configuration > Configure Power Supplies
Model
3015–3080 only
VPN 3000 Concentrator Series User Guide
This table shows current IP addresses.
.
.
.
1) Configure Ethernet #1 (Private)
2) Configure Ethernet #2 (Public)
3) Configure Ethernet #3 (External)
4) Configure Power Supplies
5) Configure Expansion Cards
6) Back
Interfaces -> _
1) Configure Ethernet #1 (Private)
2) Configure Ethernet #2 (Public)
3) Configure Power Supplies
4) Configure Expansion Cards
5) Back
Interfaces -> _
1) Enable/Disable
2) Set IP Address
3) Set Subnet Mask
4) Select IP Filter
5) Select Ethernet Speed
6) Select Duplex
7) Set Port Routing Config
8) Set Public Interface
9) Back
Ethernet Interface 1 -> _
Alarm Thresholds in centivolts (e.g. 361 = 3.61V)
Voltages will be adjusted to conform to the hardware.
1) Configure CPU voltage thresholds
2) Configure Power Supply 1 voltage thresholds
3) Configure Power Supply 2 voltage thresholds
4) Configure Board voltage thresholds
5) Back
Interfaces -> _
CLI menu reference
16-9