Notice To Users Of Certified Component Devices - Cisco VPN 3000 User Manual

B
Copyrights, licenses, and notices
(1) --------------------------------
(2) Before connecting your unit, you must inform the telephone company of the following information:
Port ID
Port 0, 1
(3) If the unit appears to be malfunctioning, it should be disconnected from the telephone lines until you learn if
your equipment or the telephone line is the source of the trouble. If your equipment needs repair, it should not be
reconnected until it is repaired.
(4) If the telephone company finds that this equipment is exceeding tolerable parameters, the telephone company
can temporarily disconnect service, although they will attempt to give you advance notice if possible.
(5) Under the FCC Rules, no customer is authorized to repair this equipment. This restriction applies regardless of
whether the equipment is in or out of warranty.
(6) If the telephone company alters their equipment in a manner that will affect use of this device, they must give
you advance warning so as to give you the opportunity for uninterrupted service. You will be advised of your right
to file a complaint with the FCC.
(7) The attached Affidavit (Appendix A) must be completed by the installer.
(8) Service Requirements: In the event of equipment malfunction, all repairs should be performed by our
Company or an authorized agent. It is the responsibility of users requiring service to report the need for service to
our Company or to one of our authorized agents. Service can be facilitated through our office at:

Notice to Users of Certified Component Devices

The following instructions are provided to ensure compliance with the Federal Communications Commission (FCC)
Rules, Part 68.
This equipment is certified with the FCC under Part 68 as a component device for use with the following Cisco
Systems host routers:
In order for the FCC certification of this product to be retained, all other products used in conjunction with this
product must also be FCC Part 68 certified for use with these hosts. If any of these components are not certified,
then you are required to obtain FCC Part 68 certification of the assembled equipment prior to connection to the
telephone network. Part 68 certification requires that you maintain this approval and as such are responsible for the
following:
•
Any component added to your equipment, whether it bears component certification or not, will require a Part 68
compliance evaluation. You may need to test and make a modification filing to the FCC before that new
component can be used;
•
Any modification/update made by a manufacturer to any certified component within your equipment, will require
a Part 68 compliance evaluation. You may need to test and make a modification filing to the FCC before that
modified component can be used;
•
If you continue to produce this compound you are required to comply with the FCC's Continuing Compliance
requirements. Therefore is it recommended that only FCC Part 68 certified devices bearing the 'CN' or 'CE'
equipment code as part of the FCC certification number, be used (NOTE: The host equipment used in conjunction
with this product may bear an FCC Certification number with other than the 'CN' or 'CE' equipment code). In
determining if your particular component device is appropriately approved, look for the FCC certification number
on all components and ensure that the classification code '-CN-' or '-CE-' is part of that number. Refer to the
FCC Certification number on this product as an example.
B-10
REN/SOC
6.0N
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
FIC
04DU9-1SN
VPN 3000 Concentrator Series User Guide
USOC
RJ48C