Deploying 10-Gigabit Ethernet And Gigabit Ethernet Sfp Ports On Supervisor Engine V-10Ge - Cisco Catalyst 4500 Series Software Configuration Manual

The output for the show idprom tengigabitethernet slot/interface command displays the contents of both the SFP+ and the
OneX Convertor module SEEPROMs when an SFP+ in a OneX Convertor module is plugged into an X2 port.
Deploying 10-Gigabit Ethernet and Gigabit Ethernet SFP Ports on
Supervisor Engine V-10GE
On a Catalyst 4510R series switch, if you enable both the 10-Gigabit Ethernet and Gigabit Ethernet SFP
Note
uplink ports, you must reboot the switch. On the Catalyst 4503, 4506, and 4507R series switches, this
capability is automatically enabled.
Prior to Cisco IOS Release 12.2(25)SG, you could enable either the dual wire-speed 10-Gigabit Ethernet ports or four
alternatively wired Gigabit Ethernet SFP uplink ports.
Beginning with Cisco IOS Release 12.2(25)SG, you could simultaneously deploy the dual 10-Gigabit Ethernet ports and the
four Gigabit Ethernet SFP ports on the Catalyst 4503, Catalyst 4506, and Catalyst 4507R chassis.
When you deploy a Catalyst 4510R chassis, one of the following configurations is supported:
Dual 10-Gigabit Ethernet ports (X2 optics) only.
•
Four Gigabit Ethernet ports (SFP optics) only.
•
• Both the dual 10-Gigabit Ethernet and the four Gigabit Ethernet ports. The tenth slot (Flex-Slot) only supports a 2-port
gigabit interface converter (GBIC) line card (WS-X4302-GB) when in this mode.
You cannot place a line card with a backplane traffic capacity exceeding 6 Gbps in slots 8, 9, and 10 of a Catalyst 4510R-E
•
chassis when used with a Supervisor Engine 6-E or 6L-E.
To select the 10-Gigabit Ethernet or the Gigabit Ethernet SFP uplink port, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# hw-module uplink select [all |
gigabitethernet | tengigabitethernet]
The following example shows how to enable both 10-Gigabit Ethernet and Gigabit Ethernet SFP uplink ports on a Catalyst
4510R series switch:
Switch# configure terminal
Switch(config)# hw-module uplink select all
Warning: This configuration mode will place slot 10 in flex slot mode
When you modify the uplink mode, you must reboot the switch.
Note
Deploying 10-Gigabit Ethernet and Gigabit Ethernet SFP Ports on Supervisor
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
9
Purpose
Establishes global configuration mode.
Selects the port type to enable.
Chapter 9 Configuring Interfaces