Check And Clear Of Mtbf Information - NEC Express 5800 User Manual

Check and Clear of MTBF Information

The MTBF information of a component can be viewed or cleared (initialized).
NEC Express5800/ft series manages the MTBF (mean time between failure) of each component. If
a fault occurs in a component, the NEC Express5800/ft series calculates the MTBF of the
component again. If the calculated value is lower than the pre-defined threshold, the NEC
Express5800/ft series disables the component to be used.
Contact your maintenance personnel if such a symptom as above occurs.
A disabled component with the MTBF lower than the threshold can be forcibly
IMPORTANT:
enabled by clearing the MTBF. However, contact your maintenance personnel for the forced use of
such a component.
To clear the MTBF information of a component with NEC ESMPRO Manager, use the
[Maintenance] tree of the component of the [FTServer] tree of the data viewer. Open the tree of the
component whose MTBF information is to be cleared and select the [Maintenance] tree.
To clear the MTBF information of a component with the ft server utility, use the utility screen of the
component. The table below shows the potential cases in which the MTBF information of a
component is to be cleared. Contact your maintenance personnel for clearing MTBF information.
Component
CPU Module To start the module forcibly after
replacing a module or if MTBF became
lower than the threshold due to
malfunction and disabled the module.
Executable in the following module
state (this can be viewed on manager
screen):
•
Broken
MTBF is lower than the threshold.
PCI Module Same as above
Ethernet To start the module/component forcibly
Adapter after replacing a module or if MTBF
became lower than the threshold due
to malfunction and disabled the
module/component.
Executable in the following module
state (this can be viewed on manager
screen):
Broken
MTBF is lower than the threshold.
You can clear MTBF information by
unplugging and plugging the live wire
of the PCI module.
SCSI Adapter -
MTBF clear
Remote
Installing and Using Utilities
Local
To start the module forcibly after replacing
a module or if MTBF became lower than
the threshold due to malfunction and
disabled the module.
Executable in the following module state:
•
Only the red LED is on and the event
indicating that MTBF is lower than the
threshold is registered in the event log.
Same as above
To start the module/component forcibly
after replacing a module or if MTBF
became lower than the threshold due to
malfunction and disabled the
module/component.
Executable in the following module state
(this can be viewed on manager screen):
•
Only the red LED is on and the event
indicating that MTBF is lower than the
threshold is registered in the event log.
You can clear MTBF information by
unplugging and plugging the live wire of
the PCI module.
Same as above
5-49