NEC Express 5800 User Manual page 268

On-screen error message
0232 Extend RAM Failed at
address line
0233 Memory type mixing
detected
0234 Single - bit ECC error
0235 Multiple - bit ECC error
0250 System battery is dead
-Replace and run
SETUP
0251 System CMOS
checksum bad-Default
configuration used
0252 Password checksum bad
-Password cleared
0260 System timer error
0270 Real time clock error
0271 Check date and time
setting
0280 Previous boot incomplete
-Default configuration
used
02B0 Diskette drive A error
02B2 Incorrect Drive A type -
run SETUP
02D0 System cache error -
Cache disabled
0B1B PCI System Error on
Bus/Device/Function
0B1C PCI Parity Error on
Bus/Device/Function
0B22 CPUs are installed out of
order
0B28 Unsupported Processor
detected on Processor 1
Cause
DIMM is faulty.
DIMMs of the different types
are installed.
DIMM is faulty.
DIMM is faulty.
NvRAM battery is dead.
NvRAM is faulty.
NvRAM is faulty.
PCI module board is faulty.
RTC is faulty.
Date and time of RTC are
incorrectly set.
Configuration error in Setup
menu.
Floppy drive A is faulty.
Configuration error in Setup
menu.
•
CPU is faulty.
•
CPU module board is faulty.
PCI device is faulty.
PCI device is faulty.
CPU is faulty.
The processor (CPU) not
supported by this server is
installed in Processor 1.
Troubleshooting
Action
•
Replace DIMM.
•
Replace the CPU module
board.
Replace DIMM with
appropriate one.
•
Replace DIMM.
•
Replace the CPU module
board.
•
Replace DIMM.
•
Replace the CPU module
board.
Replace the PCI module
board.
•
Re-configure using the
Setup menu.
•
Replace the PCI module
board.
•
Re-set the password in the
Setup menu.
•
Replace the PCI module
board.
Replace the PCI module
board.
Replace the PCI module
board.
•
Set the correct date and time
in Setup menu.
•
Replace the PCI module
board.
Check configuration in Setup
menu.
Replace the floppy disk drive
A.
Specify the correct drive type
in Setup menu.
•
Replace the CPU.
•
Replace the CPU module
board.
•
Replace the PCI board.
•
Re-install the PCI board.
•
Re-configure the PCI board.
•
Replace the PCI module
board.
Replace the CPU.
Install the CPU appropriate to
the server.
7-15