NEC Express 5800 User Manual page 351

8-50 System Upgrade
2.
Build a dual LAN configuration. (See "Setting Dual LAN Configuration" in the separate
volume "User's Guide (Setup).")
IMPORTANT:
You can also select [Load Balancing] in step 3 in "Setting Dual LAN Configuration". In
this case, [Team #1:Adaptive Load Balancing Mode] is added to Network Component
Tree.
Moreover, select [NEC 8490XT Copper Gigabit Adapter] instead of [Stratus emb-82559
10/100 Enet Adapter] in Steps 4 and 5.
PCI Board Status LED Indications
LED
Description
indications
Green Duplex is specified,
however, the server works
in simplex mode.
Off PCI board is properly
installed and operates in
non-duplex mode (AFT,
ALB). (Does not depend on
simplex or duplex.)
PCI board is installed to
operate in the duplex mode.
The PCI board is not
installed yet, the PCI board
is installed incorrectly, or the
power is not supplied.
Red In the process of configuring
or canceling the duplex
mode
Although the PCI board is
mounted, it may be offline
or not be working.
Action
Specify duplex (AFT, ALB).
Specify an appropriate driver.
In non-duplex mode, no special problem
occurs.
The system is operating normally in duplex
mode.
Mount the PCI board correctly.
If the PCI board was not mounted, there is no
problem.
Check the condition of power unit.
Remount the PCI module.
Wait for a while until the indication changes. If
the indication unchanged, check the PCI
board slot status using NEC ESMPRO
Manager.
Make the slot of the board installed from NEC
ESMPRO Manager online.
Mount the PCI board correctly.