NEC Express 5800 User Manual page 237

5-74 Installing and Using Utilities
Connect from the Management PC Linked through LAN
On the management PC that is linked through LAN, perform the steps below:
Start the management PC where NEC MWA is installed. From the Start menu, select
1.
[Program] → [NEC MWA] → [MWA].
When NEC MWA starts, the initial screen "Remote Control Manager" will appear.
Insert a formatted 1.44MB floppy disk into the drive.
2.
From NEC MWA's [File] menu, select [Configuration] command to open [Configuration]
3.
dialog box.
Select [New] to display the [Select a model] dialog box.
4.
Check [Write to FD] and select an applicable model to open [Configuration for ft Server]
5.
dialog box.
Ex) The model name is printed on the front cover like "NEC Express5800/320Lc," or
"NEC Express5800/320Lc-R."
On the [Configuration for ft Server] dialog box, specify/register configuration information
6.
including the names of computers to be managed, and then write the information to FD as
the following filename:
<Filename>
CSL_LESS.CFG
The setting items of the server are as follows:
Computer Name (The managed server name. Arbitrary)
IP address
Subnet mask
Default gateway
Primary contact (Management PC's IP address)
Right-click the server name to open the pop-up menu, from which select [Property]
7.
command to open [Property] dialog box.
When the [Property] dialog box appears, specify the items as follows:
8.
<[ID] page>
Connection mode:
<[Alert notification] page>
Uncheck [Use Default Settings] and check [Reset] of [Activate].
LAN