Avaya AP-4 User Manual page 79

6. Remove the front cover from the unit. See
Cover for an illustration.
7. Remove the back cover from the unit. See
Cover for an illustration.
8. Place the back cover on the mounting location and mark the center
of the three mounting holes.
9. Remove the cover from the wall and drill a hole at each of the
locations you marked above. Each hole should be wide enough to
hold a mounting plug (which is 6 mm x 35 mm).
10. Insert a plug into each hole. The AP comes with four 6 mm x 35
mm plugs; you only need to use three of these when wall mounting
the unit.
11. Insert a screw into each of the mounting holes molded into the
back cover. The AP comes with four 3.5 mm x 40 mm pan-head
screws; you only need to use three of these when wall mounting
the unit.
12. Insert the screws into the wall plugs. Use a screwdriver to tighten
the screws and attach the back cover to the wall. In the following
example, the back cover is mounted upside down (the two holes
are at the bottom).
Avaya Wireless AP-4/5/6 User's Guide
Additional Hardware Features
Remove the Front
Remove the Back
2-49