Avaya AP-4 User Manual page 181

Follow these steps to configure the Ethernet Protocol Filter:
1. Select the interface or interfaces that will implement the filter from
the Ethernet Protocol Filtering drop-down menu.
— Ethernet: Packets are examined at the Ethernet interface
— Wireless: Packets are examined at the Wireless interface
— All Interfaces: Packets are examined at both interfaces
— Disabled: The filter is not used
2. Select the Filter Operation Type.
— If set to Passthru, only the enabled Ethernet Protocols listed
in the Filter Table will pass through the bridge.
— If set to Block, the bridge will block enabled Ethernet
Protocols listed in the Filter Table.
Avaya Wireless AP-4/5/6 User's Guide
Filtering
4-83