Avaya AP-4 User Manual page 177

Set up Automatic Configuration for Dynamic IP
Perform the following procedure to enable and set up Automatic
Configuration when you have a dynamic IP address for the TFTP server
via DHCP.
The Configuration filename and the TFTP server IP address are
contained in the DHCP response when the AP gets its IP address
dynamically from the DHCP server. A Syslog server address is also
contained in the DHCP response, allowing the AP to send Auto
Configuration success and failure messages to a Syslog server.
NOTE:
The configuration filename and TFTP server IP address are
configured only when the AP is configured for Static IP. If the AP is
configured for Dynamic IP these parameters are not used and
obtained from DHCP.
1. Click Configure > Management > AutoConfig. The
Configuration Screen
2. Check Enable Auto Configuration.
When the AP is Configured with Dynamic IP, the DHCP server
should be configured with the TFTP Server IP address (Boot
Server Host Name, option 66) and Configuration file (Bootfile
Name, option 67) as follows:
3. Select DHCP Server > DHCP Option > Scope. The DHCP
Options: Scope Screen appears.
Avaya Wireless AP-4/5/6 User's Guide
appears.
Management
Automatic
4-79