Supplying Power; Initial Setup - Sony XDS-1000 Operation Manual

Preparations

Supplying Power

Connect the AC power input connector to an AC power
source using the specified AC power cord. To supply
power, set the main power switch on the rear panel to on,
and then press the on/standby (1) button on the front panel
and hold it down for a short time (0.25 seconds or longer).
Note
To switch the state of this unit from standby state (the main
switch on the rear panel is on) to operative state, wait at
least three seconds after the unit has entered standby state
and then press the on/standby button on the front panel.
Chapter

Initial Setup

This unit is shipped with the area of use, system frequency,
and current date and time still unset.
Therefore, you need to make initial setup settings before
using the unit. (You cannot use the unit without setting it
up.)
Once the unit has been set up, the settings are retained even
when the unit is powered off.
To set the area of use and system
frequency
1
Power the unit on.
The INITIAL SETUP screen appears on the display.
3
Supplying Power / Initial Setup
29