Swapping The Speed Setting; Resetting The Trip Distance; Returning To The Manually Set Altitude; Restarting The Interval Or Recovery Calculation - Polar Electro S625X User Manual

Tips during the exercise Swapping the speed settings (--, ru, b1 or b2)
In the Measuring mode press and hold the down button. Release. Repeat
until Run speed, Bike 1 or 2 or Speed Off is displayed. You can now exercise
with the chosen settings. From running to cycling and vice versa can be
swapped in the BasicUse (E0) mode, if the exercise is paused. A new file is
created if you change the speed settings.

Resetting the trip distance

Start from the Measuring or Recording mode. Scroll up until Trip is displayed.
Press and hold the signal/ light button until the trip reading is zero. Release.

Returning to the manually set altitude

Start from the Measuring mode. Scroll down until altitude is displayed in
the middle row. Press and hold the signal/light button until the previous
manually set altitude is displayed.
If the manually set altitude reference value deviates over ±610 m/ ±2000 ft
from the altitude calculated by the wrist unit, Failed appears and the
measured altitude appears. Set the reference altitude from the Options
mode. As you start adjusting the reference altitude, the wrist unit suggests
a measured altitude for you instead of the previously set altitude.

Restarting the interval or recovery calculation

In the Recording mode press the stop button to pause the interval or
recovery calculation.
Start resetting by pressing and holding the down button. To restart the
same calculation press the OK button or to reset the interval training
exercise, see "Resetting stopwatch to zero" section.
C 66