Table of Contents
Advertisement
5.1
Configuring – for Example with COM ET 200 Windows (Version 2.0
or Later)
Method
In the following you will find a description of the method by which you can
integrate the DP/ASi link into the PROFIBUS-DP using COM ET 200
Windows (version 2.0 or later). You will find additional information about
the different steps in the integrated online Help of COM ET 200 Windows.
1. Open the worksheet with the DP master to which you wish to connect the
2. Click in the Slaves window on ASi . As soon as you exit from the Slaves
3. Click the mouse on the point of the user interface at which you wish to
4. Select the slave station number from the list box.
5. Click OK to confirm your selection.
6. To insert further DP slaves, repeat steps 3 to 5 above.
Configuring
Once you have inserted the DP/ASi link in the PROFIBUS-DP, you have to
configure it. Proceed in the following order:
1. Click on Configure...
2. Select an ASi slave number. Double-click in the I/O field of the slave
3. Select the I/O code of your ASi slave from the list.
4. You can now edit the ID code and the parameter value of the ASi slave
5. Set the base address of the SIMATIC address assignment. You have to set
6. Assign the corresponding address assignment to the ASi slave using
7. For all the other ASi slaves you wish to connect to the DP/ASi link, re-
Distributed I/O System DP/ASi Link
EWA 4NEB 710 6055-02b
DP/ASi link.
window, the mouse pointer changes its appearance.
insert the DP/ASi link.
You can configure or assign parameters to the DP/ASi link even at this
stage by clicking once on Configure... or Parameterize....
number to go to a new input window.
you selected, the default values both being 15. If the ID code of your ASi
slave is not 15, you have to enter the corresponding value here.
In the case of a DP standard master of limited configuration – for ex-
ample, S5-95U – step 4 cannot be performed.
the base address separately for inputs and outputs only once for every
DP/ASi link.
Auto addr.
You do not obtain the final address assignment until you have
configured all the ASi slaves.
peat steps 2 to 6 above with the exception of step 5.
Configuring the DP/ASi Link
5-3
Advertisement
Table of Contents
