Barco PDS User Manual page 91

rëáåÖ=^ìíç=^ÅèìáêÉ
Please note the following important points regarding the Auto Acquire mode:
•
•
•
•
rëáåÖ=ea`m
With PDS, the HDCP mode is essentially automatic. Provided that you connect an HDCP
compliant monitor, you can select and switch between unprotected sources and "protected"
HDCP sources (e.g., a Blu-Ray player) without restriction.
•
•
•
Please note the following important points regarding HDCP operations:
•
PDS • User's Guide
If Auto Acquire is and a valid input is selected that does not have a saved
ON
Input Config file associated with it, the system attempts to acquire the source and
save an Input Config file. This process may take a few moments.
The Input Config file will only be saved if the "Auto Input
Note
Save" mode is
If an input is selected that does have a saved Input Config file associated with it,
the (blinking) source will transition to program after TAKE is pressed.
When the system performs an Auto Acquire for Inputs 5 through 8, the PDS first
checks for a DVI signal. If not found, the system looks for a valid analog signal.
If Auto Acquire is and a valid input is selected (either with or without a
OFF
saved Input Config file), the system compares the library file to the input's
incoming timing.
~ If the timings match, the system transitions to the input after TAKE is
pressed.
~ If the timings do not match, the "Invalid Signal" message appears, and
the system transitions to black after TAKE is pressed.
As a prerequisite, ensure that you have read the
Note
About
this section.
Inputs 1 through 4 (analog) are unprotected sources.
Inputs 5 through 8 (analog) are unprotected sources.
Inputs 5 through 8 (digital) are protected when an HDCP source is connected.
When the input signal is an HDCP source on DVI inputs 5 through 8 and a valid
HDCP monitor is connected, the following actions occur:
~ The PDS's analog output is disabled.
~ You cannot store a logo from a "protected" source. However,
"unprotected" logos that are already stored in the system can be
switched to Program.
~ You cannot use the FRZ button.
in the User Preference Menu.
ON
HDCP" section in Chapter 1 on page 4 prior to reading
4. Operation
Using Inputs
"A Word
77