Recall Config; Delete Config - Barco PDS User Manual

4. Operation
Setup Menu
oÉÅ~ää=`çåÑáÖ
From the Input Menu, select Recall Config to restore a configuration file that was
previously associated with the current input. Using the Recall Config Menu shown in the
following illustration, you can change from the current configuration file for the input to any
saved configuration file:
RE CA LL C O NF IG
> F i l e N u m b e r
Figure 4-21. Recall Config Menu (sample)
A number in brackets indicates the only file that is available for recall. If no files are
available, a message will be displayed to indicate that there are no saved files.
After you select a file number and choose Recall File, press SEL to initiate the recall or
ESC to continue using the current configuration.
When you press SEL, if the input timing matches the timing in the recalled input
configuration file, the input uses the recalled configuration file immediately. The File
Association Menu is also updated to reflect your change.
If the input and configuration file timings do not match and Auto Acquire is ON, an "auto
acquire" will be performed. For more information about this function, refer to the
Acquire" section on page 77.
Auto
aÉäÉíÉ=`çåÑáÖ
From the Input Menu, select Delete Config to delete any saved configuration file. A
deleted configuration file cannot be recalled by any input.
After you delete a configuration file, what happens the next time you select an input that
uses the file depends on whether Auto Acquire is
When Auto Acquire is
does a full sync (timing) acquisition on the selected input signal.
When Auto Acquire is OFF, the system will use the configuration file defined in the File
Association Menu, to the greatest extent possible. If the input does not have a saved
configuration file, the PDS displays the "Invalid Signal" message and the video output is
black.
For more information about Auto Acquire, refer to the
page 77 and the

Use the following procedure to delete a configuration file:
1.
DE LET E C O NF IG
> F i l e N u m b e r
Figure 4-22. Delete Config Menu (sample)
48
R e c a l l F i l e
and an input does not have a saved configuration file, the PDS
ON
"Auto Acquire" section on page 77.
From the Input Menu, select Delete Config. The menu shown in the following
illustration is displayed:
De lete F i le
41
(in the User Preference Menu).
ON
"Using Auto Acquire" section on
1
PDS • User's Guide
"Using