Barco PDS User Manual page 26

2. Hardware Orientation
PDS Front Panel
q~âÉ=_ìííçå
Press TAKE to mix the pending (blinking) source to Program, at the current transition rate.
Using the Setup Menu, you can adjust the transition time from 0 to 12 seconds. If the
TAKE
transition time is set to 0, the transition is a cut. Please note:
•
•
In Chapter 4, refer to the
User Preference Menu.
12
~ If "Black Auto Take" is On:
• Press BLACK to immediately transition to/from black.
–
–
Regardless of the current Black Auto Take mode, if you
Important
select (or pend) BLACK, the system will not transition to the
selected "next" source until black is fully on Program.
In Chapter 4, refer to the "Using
Each time TAKE is pressed, the current source on Program and the pending
source flip-flop. In Chapter 4, refer to the
additional details.
The TAKE button is also used to transition to/from black, when the "Black Auto
Take" function is in the User Preference Menu.
On
"User Preference
If the transition is "to" black, the button blinks fast
during the transition, then lights solid when black is on
Program.
If the transition is "from" black, the button blinks fast
during the transition, then turns off when the selected
source is on Program.
Black" section on page 81 for details.
"Flip-flop Mode" section on page 76 for
Menu" section on page 58 for details on the
PDS • User's Guide