Barco PDS User Manual page 113

4.
5.
6.
réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ

Use the following steps to upgrade PDS software:
1.
2.
3.
4.
5.
PDS • User's Guide
A message informs you if a new firmware version is available.
Re v #.#.#
available. Up grade ?
< S E L > = Y e s .
<ESC> = No.
Figure 6-5. Firmware Version-Upgrade Message
Press <SEL> to start the upgrade. A message will inform you to "Please wait...".
Ple ase wa it .. ..
Figure 6-6. Upgrade Wait Message
After the upgrade is finished, the PDS will automatically reboot.
Re se tting ....
Ple ase wa it
Figure 6-7. Resetting Message
If you are not connected to the internet, a message prompts you to check the
connection.
Ensure that your PC (or laptop) uses Windows® 7, Windows® 2000, or Windows
XP.
xConnect the PDS's Ethernet port to a Switch.
Connect the Switch to your PC (or laptop).
Power-up the PDS.
Note the PDS's current IP address:
From the Status Menu, press SEL to display the Setup Menu.
a.
Select System to display the System Menu.
b.
Select Ethernet to display the Ethernet Menu.
c.
6. Upgrading Firmware
Upgrading Firmware Using the Web Upgrade
99