Barco PDS User Manual page 111

Figure 6-1. Format Removable Disk Window
6.
7.
mÉêÑçêãáåÖ=íÜÉ=cáêãï~êÉ=réÖê~ÇÉ=rëáåÖ=íÜÉ=rp_=mçêí

To upgrade the PDS firmware via the USB port, use the following procedure:
1.
2.
PDS • User's Guide
Then click Start. A message appears, warning that data will be erased during the
formatting process.
~ Click OK to continue.
~ Click Cancel to halt the process.
If you click OK, a confirmation message appears after a few seconds. The flash
drive is now ready to use.
If you click Cancel, you can delete data or download it to the computer, then retry
the formatting operation.
After unzipping the firmware upgrade downloaded from the
Important
Barco Web Site or FTP site, make sure the PDS_##_##.tar.gz
file is in a directory named "PDS" before inserting the USB
Flash drive into the PDS's USB port.
Insert the USB Flash drive into the PDS's USB port.
Select Firmware Upgrade from the Setup Menu. The Firmware Upgrade
Submenu appears.
F I R M W A R E UP GR A D E
> USB Upgrade
Web Upgrade
Figure 6-2. Code Upgrade Submenu
6. Upgrading Firmware
Upgrading Firmware Using the USB Port
>>
>>
97