Barco PDS User Manual page 28

2. Hardware Orientation
PDS Rear Panel
2)
3)
4)
5)
6)
7)
8)
14
• 1920x1200@60 (193.25 MHz)
• 2048x1080p@60 (183.75 MHz)
~ Composite and S-Video formats are supported.
In Chapter 3, refer to the "Format Connection
table of analog inputs that you can connect using a customer-supplied breakout
cable. In Appendix A, refer to the
page 109 for pinouts.
DVI and Analog Inputs
Four DVI-I connectors are provided on the PDS-902 and PDS-901, and two on the
PDS-701, for both digital and analog inputs.
~ Using the connector's digital pins, an 8-bit digital input is supported.
~ Using the connector's analog pins, RGBHV, analog composite, S-Video,
and YUV formats are supported. A customer-supplied breakout cable or
DVI to HD-15 adapter is required for these connections.
In Appendix A, refer to the
3G/HD/SD SDI Input
One BNC connector is provided for the SD-SDI, HD-SDI, or 3G-SDI input.
Main Outputs
Two connectors are provided for the PDS's main program outputs. Both outputs
have the same resolution, and both can be used simultaneously.
~ One DVI-I connector is provided for the system's digital program output.
There are no analog outputs on this connector. In Appendix A, refer to
the "DVI-I Connector" section on page 110 for pinouts.
The DVI-I connector allows you to use both DVI-D and DVI-I
Note
cables as required.
~ One HD-15 connector is provided for the system's analog output. In
Appendix A, refer to the
page 109 for pinouts
Ethernet
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the PDS system. The port is used for running the built-in web-based GUI, for
diagnostics, or for command-line operations via Telnet (using port 23).

telnet 192.168.0.10 23
In Appendix A, refer to the
AC Power
One AC Connector is provided for connecting PDS to AC. The integral switch
turns the chassis on and off. In Appendix A, refer to the
Specifications" section on page 108 for power details.
Preview Outputs
Two outputs are provided on the PDS-902 for connecting to the Preview monitor:
an HD-15 connector for analog monitors and a DVI connector for digital displays.
Serial
One DB-9 connector is provided for Serial communications with the PDS system.
The port is also used for diagnostics or command-line operations.
Table" section on page 20 for a
"Analog 15-pin D
"DVI-I Connector" section on page 110 for pinouts.
"Analog 15-pin D Connector" section on
"Ethernet Connector" section on page 111 for pinouts.
Connector" section on
"Physical and Electrical
PDS • User's Guide