Barco PDS User Manual page 79

Ne tmask
>
Figure 4-42. Netmask Menu (sample)
G a t e w a y
>
Figure 4-43. Gateway Menu (sample)
PDS • User's Guide
~ Select Set Netmask to display the Netmask Menu, which enables you
to set a netmask. The editing procedure is discussed below.
255.255.255.000
~ Select Set Gateway to display the Gateway Menu, which enables you to
set a gateway. The editing procedure is discussed below.
192.168.000.002

Use the following steps to edit the IP address, Netmask or Gateway. Valid
fields range from 000 to 255.
Press SEL to begin editing. This action highlights the first digit, and
a.
displays the carat "^."
Use the ADJUST knob to move the carat left and right through the
b.
address.
When the desired digit is highlighted, press SEL to edit the value. The
c.
carat changes to the pound sign "#."
Use the ADJUST knob to select the desired value (0 - 9).
d.
Once the value is selected, press SEL to "accept" the new value. The
e.
pound sign "#" changes back to the carat "^."
Repeat the process from step b for all additional digits that you wish to
f.
change.
When complete, press ESC to display the Apply Changes Menu.
g.
• Select
Yes
• Select
No
In each case, system returns to the root menu.
When Ethernet setup is complete, you can communicate with the PDS via the
Ethernet port.
~ In Appendix B, refer to the
for details on communicating with the PDS via Telnet.
~
In Chapter 5, refer to the
page 86 for details on running the web-based GUI.
(SEL) to apply all changes.
(ESC) to exit the procedure without saving changes.
"Remote Commands" section on page 123
"GUI Connection and
4. Operation
Setup Menu
Launch" section on
65