Barco PDS User Manual page 74

4. Operation
Setup Menu
•
^ìíç=fåéìí=`ÑÖ
The Auto Input Cfg function enables or disables the automatic input configuration mode.
Values are:
•
•
^ìíç=fåéìí=p~îÉ
When the Auto Input Save mode is enabled, the system automatically saves the selected
input after it has been acquired for the first time. If the Auto Acquire mode is OFF, the field
has no effect. The default is OFF.
_~ÅâÖêçìåÇ
From the User Preference Menu, select Background to change the system's background
color between "Black" and "Gray." This is a global setting.
When set to Gray, you can clearly see the edges of an input, particularly when the input's
aspect ratio does not match the output's aspect ratio. Note that the background selection
persists between source changes.
60
If you are an advanced user and you know the exact timing parameters for your
input(s), you can turn the Auto Acquire mode ALLOFF, and dial in your timing
parameters manually.
If you have already saved configuration files for your inputs, it
Tip
is recommended that you turn the Auto Acquire mode
ALLOFF. This provides the fastest transition times. When
the mode is
the time required to analyze the input timing for each source.
and (default).
ON OFF
This is the "automatic" version of the manual Auto Input Cfg
Note
mode, which is located in the Input Sizing Menu. Refer to
the "Sizing
When ON, the system automatically finds the first and last pixel on each edge of
the selected input, and ensures (to the best possible extent) that the entire image
is visible. In addition, the system automatically phases the input to determine the
correct sampling phase.
These functions will only be performed under the following conditions:
~ When an input without a saved configuration file is selected.
~ When the input signal changes sync rates.
~ When an input with a saved configuration file is selected, but the input
timing is different from the saved configuration.
When OFF, the system uses the last known configuration for each input, to the
greatest extent possible.
ON, transition times will be greater, due to
ALL
Adjust" section on page 41 for details.
PDS • User's Guide