Save Config; Reset Config - Barco PDS User Manual

4. Operation
Setup Menu
•
^Äçìí=fåéìí=`çåÑáÖìê~íáçå=cáäÉë
The PDS supports saving up to 64 input configuration files in non-volatile memory, each of
which is available to the nine physical inputs (1 through 8 and SDI).
Input configuration files contain settings that govern everything from pixel resolution to
aspect ratio and color balance — any setting you can view or change using the Input
Menu. By default, an input's configuration file number is the same as the number of the
input — Input 1 is assigned to configuration file number 1, and so on. You can set, delete,
save, or recall the configuration file for an input. You can associate any number of saved
files to any number of inputs.
When you change the configuration file for an input, the timing in the new configuration file
must match the input's timing. For example, if the input uses NTSC (720 x 480) timing, that
input cannot use a configuration file that uses WXGA (1280 X 768).
When you delete user-defined configuration files, those files are no longer available for use
by any input.
For more information about using input configuration files, refer to the following sections:
•
•
•
•
p~îÉ=`çåÑáÖ
After you use the Input Menu to change one or more input settings, you can save the
changes to non-volatile memory by selecting Save Config. You can save the changes to
the current configuration file for the selected input, or to a different file.

To save changes to an input's configuration, use the following procedure:
1.
SA VE CONFIG
> F i l e N u m b e r
Figure 4-18. Save Config Menu (sample)
2.
46
~ range: OFF, ON
Adjustment
~ Default: OFF
Sync Slice — This function selects the sync comparator threshold for RGsB
(RGB with Sync on Green) or YP
PDS detects Macrovision copy protection on the incoming YP
video, the Sync Slice value is automatically repositioned to 60mV to account for
the reduced amplitude sync pulse.
~ range: 8mV to 256mV, adjustable in steps of 8mV
Adjustment
~ Default: 128mV

Save Config

Reset Config

Recall Config
Delete Config
Select Save Config from the Input Menu. The menu shown in the following
illustration appears:
S a v e F i l e
Select a value for File Number, or keep the default file number.
P analog component video sources. When
b r
24
P NTSC/PAL
b r
PDS • User's Guide