Barco PDS User Manual page 75

ea`m
The HDCP Submenu, shown in the following illustration, lets you set HDCP capability for
inputs. For an introduction to HDCP, see
HD CP
> I n 5 ( D V I - I)
The HDCP setting is either
and outputs:
•
•
•
•

To turn HDCP capability on or off, use the following procedure:
1.
2.
3.
^ìíç=q~âÉ
The Auto Take mode allows you to bring an input source to Program by simply pressing an
input button (1 through 8, SDI, or LOGO), and without requiring a Take.
Regardless of your Auto Acquire settings, the input button you select blinks slow, to
indicate that the system is performing an action such as an auto acquire, file association, or
another action. When the system completes its tasks for the input, the button lights solid
and the source goes to Program automatically.
•
•
_ä~Åâ=^ìíç=q~âÉ
The Black Auto Take function controls the behavior of the BLACK button:
•
•
Refer to the
PDS • User's Guide
I n 6 ( D V I- I)
I n 7 ( D V I- I)
I n 8 ( D V I- I)
or OFF. You can set this capability for the following inputs
ON
In 5 (DVI-I) — The default setting is OFF.
In 6 (DVI-I) — The default setting is OFF.
In 7 (DVI-I) — The default setting is OFF.
In 8 (DVI-I) — The default setting is OFF.
In 7 and In 8 are not available for selection in PDS-701 units.
Note
On the Setup Menu, select User Preference.
On the User Preference, select HDCP. The HDCP Submenu appears.
Select an input or output and turn the ADJUST knob once. Then press SEL.
When ON, Auto Take overrides user preferences for Black Auto Take. The value
for this menu item is bracketed.
When OFF, the selected input button blinks slow. Press TAKE to perform the
transition.
When ON, the BLACK button transitions the Program output to/from black, as
soon as the button is pushed.
When OFF, the BLACK button blinks when pressed, to indicate "pending." Press
TAKE to perform a transition to/from black.
"Using Black" section on page 81 for details.
"A Word About HDCP" on page 4.
O f f
O n
O f f
O f f
4. Operation
Setup Menu
61