Barco PDS User Manual page 117

qêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå

Use the following steps to determine the IP address of the PDS, and establish proper
communications:
1.
2.
3.
PDS • User's Guide
Power-up the PDS.
Note the PDS's current IP address:
From the Status Menu, press SEL to display the Setup Menu.
a.
Select System to display the System Menu.
b.
Select Ethernet to display the Ethernet Menu.
c.
Make a note of the information on the IP line, which shows the current IP
d.
address in all modes (with DHCP on or off).
Attempt to ping the PDS as follows:
Connect the PDS's Ethernet port to a Switch.
a.
Connect the Ethernet Switch to your PC.
b.
Turn on the PC or laptop.
c.
Open a command prompt window on the PC. Click Start > Programs >
d.
Accessories > Command Prompt.
On the command prompt line, type:
e.
ping 192.168.0.10
... followed by Enter.
Use the unit's actual IP address, as determined in step 2
Note
above.
If the computer can successfully communicate with the PDS, you will see
f.
a series of "replies" from the target IP address. Repeat the upgrade
procedure as outlined in the
Upgrade" section on page 98.
If you see a "Request timed out" message, the PC is unable to locate
g.
the PDS. If this is the case:
• Check your network connections and settings as described
above, or,
• Contact your network administrator, or,
• Contact Technical Support. In Appendix C, refer to the
"Contact
6. Upgrading Firmware
Upgrading Firmware Using the Web Upgrade
"Upgrading Firmware Using the Web
Information" section on page 150 for details.
103