Barco PDS User Manual page 61

3.
Figure 4-19. Saving Input File message (sample)
If you change a setting in the Input Menu and press ESC without saving changes, your
change will not be restored the next time you select the input or power up the system. The
system displays the following prompt:
Figure 4-20. Save Input Configuration Prompt (sample)
•
•
oÉëÉí=`çåÑáÖ
From the Input Menu, select Reset Config to remove all user-entered configuration
settings from the current input on Program, and restore the input's parameters from the
system's internal library values. When you select Reset Config, you will be prompted to
reset (SEL) or continue without resetting (ESC).
Note that if the current format was derived as a best guess, those "guess" values are
restored when you press SEL.
PDS • User's Guide
If you save to another configuration file, the File Association Menu is updated to
associate the new file to the current input. For more information about the File
Association Menu, refer to the
You can assign a configuration file to more than one input. If
Important
you do so, you must exercise caution when deleting the file,
because it will be deleted for all inputs.
Scroll down to Save File and press SEL.
A confirmation message is briefly displayed, after which the system returns to the
Input Menu.
Savin g Inpu t File
Sa ve Input Cf g?
< S E L > = Y e s
< E S C > = N o
Press SEL to save changes.
Press ESC to exit without saving.
Resetting configuration parameters does not change the
Note
configuration file associated with the input — it simply assigns
the restored parameters to the existing configuration file. The
file number shown in the File Association Menu does not
change.
"File Association" section on page 70.
4. Operation
Setup Menu
47