Using Freeze; Black Auto Take Off; Black Auto Take On - Barco PDS User Manual

rëáåÖ=cêÉÉòÉ
You can use the FRZ (Freeze) button to create a still image from a video image, typically
for use as a full-screen logo.

Use the following steps to freeze and un-freeze an input:
1.
FRZ
2.
3.
rëáåÖ=_ä~Åâ
The BLACK button is used to transition the system's output to/from black, no matter what
combination of sources are currently on Program. For example:
BLACK
•
When BLACK is pressed, one of two different actions can occur, depending on how the
"Black Auto Take" function is set in the User Preference Menu.
•
•
_ä~Åâ=^ìíç=q~âÉ=lÑÑ==
When the "Black Auto Take" function is
the TAKE button to transition to/from black.

Use the following steps to transition to/from black, when Black Auto Take is OFF:
1.
2.
PDS • User's Guide
Select the desired input and transition it to program with a TAKE.
Press FRZ to immediately freeze the source. The button lights.
To un-freeze the source, press FRZ again. The light turns off.
When a "protected" HDCP source is selected (inputs 5
Important
through 8), you cannot use the FRZ button.
If a single source is on Program (e.g., Input 1), the system will mix to black at the
current transition rate.

Black Auto Take Off

Black Auto Take On

Refer to the
Note
details on setting parameters in the User Preference Menu.
Press BLACK. The button blinks to indicate that a transition to/from black is
pending.
Press TAKE. The system transitions to/from black, at the current transition rate.
Please note:
~ If the transition is "to" black, the BLACK button lights solid when black is
fully on Program.
"User Preference Menu" section on page 58 for
in the User Preference Menu, you must use
OFF
4. Operation

Using Freeze

81