Preparing For Installation; Tools & Parts Required - Avaya IP Office 3.0 Installation Manual

Preparing for Installation

Preparing for Installation
This section reviews the requirements for installing an IP Office system. You must meet these
requirements for the system to operate safely and in the intended manner.
This section covers :
• Tools & Parts Required.
• Space requirements
• Environmental requirements
• Power Supply requirements
Tools & Parts Required
• General
• Pozidrive No. 1 screwdriver for removal of unit covers.
• Cutter/knife for cable ties.
• Cable ties - 3mm x 50mm.
• Pozidrive No. 4 screwdriver for Analog Trunk 16 expansion module grounding post.
• Note:
In addition, ensure that you have sufficient cables that are not supplied with the
modules, e.g. power supply cables.
•
Programming
These are the tools required for programming of a newly installed IP Office system.
• PC running Windows 2000/XP or NT with the following specification:
•
•
• IP Cat.5E patch cable (red - supplied with control unit).
•
IP Office Administration CD.
•
IP Office Manager Application Manual.
• IP Office Feature Key (where software that requires a Licence Key is to be installed).
Installation Manual
IP Office 3.0
Intel Pentium ll 333Mhz or faster, 100MB HD space, CD-ROM drive, COM port,
terminal emulation (e.g. HyperTerminal) and a super VGA Monitor (set to
1024x768).
PC with a LAN card with either a fixed IP address (allocated by your system
administrator) or be using DHCP to obtain an IP address.
40DHB0002UKCL Issue 12c (24th February 2005)
Page 35