Ip403 Office - Front View - Avaya IP Office 3.0 Installation Manual

IP Office Installation

IP403 Office - Front View

• DS Ports
DS ports support Avaya 24xx, 44xx, 54xx and 64xx series telephones. These ports support either
A-Law or mu-Law PCM encoding (default is country dependant and can be switched in software -
refer to the Administration Manager Manual for details). Using standard structured wiring, these
RJ45 ports can be extended to the required telephone location. When telephones are equipped
with line cords that terminate in RJ11 plugs then, although their wiring is compatible, it is
advisable to use pin-to-pin RJ11/RJ45 adapters.
•
Plain Ordinary Telephone (POTS) Ports
These two ports are used for connection to standard analog telephones, fax machines and
modems. They must not be connect to trunks. Using standard structured wiring, these RJ45
ports can be extended to the required telephone location. Converters can be used to provide BT
New Plan sockets (431A/631A) if required. When devices are equipped with line cords that
terminate in RJ11 plugs, then pin-to-pin RJ11/RJ45 adapters should be used.
•
LAN Ports
The eight auto-negotiating 10/100 BaseT LAN hub ports are used for PC and server connectivity.
They can also be used to connect to the optional IP400 WAN3 Expansion Module and IP
telephones. LAN ports allow information relating to incoming and outgoing telephone calls to be
forwarded to PC based applications. They also provide access to the router
functionality/configuration of the IP403 Office platform for both data and Voice over IP (VoIP)
calls. (Where IP telephony is required, a suitable switch LAN switch with QoS capabilities.) This
eight port auto-negotiating 10/100 BaseT LAN hub has a single MAC address (printed on the
base of the unit). Where more than eight LAN connections are required, the eighth LAN port can
be used for cascading to other hubs. The Uplink push button to the right of this port is used to
set the mode. When the Uplink switch is in the out position the port can be connected to another
hub without the need for a crossover cable, i.e. the port is an MDI type port. When the Uplink
switch is in the in position the port can be connected directly to a PC.
•
Cables
IP403 Office DS PRI 24 T1 are supplied with one red CAT5E cable. IP403 Office DS Analog 4
are supplied with four red CAT5E cables. For Port Pinouts and Cables, refer to Port Pinouts and
Cables respectively.
Installation Manual
IP Office 3.0 40DHB0002UKCL Issue 12c (24th February 2005)
Page 10