Avaya IP Office 3.0 Installation Manual page 93

The traps above are generated for the physical entities as follows:
•
Expansion Modules
Trap Type
ipoGenEntityFailureEvent
ipoGenEntityOperationalEvent Yes
ipoGenEntityErrorEvent
ipoGenEntityChangeEvent
Where:
•
ipoGenEntityFailureEvent and ipoGenEntityOperationalEvent traps are issued in relation
to connecting cable disconnection and reconnection or power changes.
• ipoGenEntityErrorEvent trap is issued for transitory communication errors across the
cabling to an expansion module.
• ipoGenEntityChangeEvent trap is issued for mismatch(es) in expansion modules
discovered at controller start up and those present in the system configuration.
• Trunk Interfaces
Trap Type
ipoGenEntityFailureEvent
ipoGenEntityOperationalEvent No
•
Where ipoGenEntityFailureEvent and ipoGenEntityOperationalEvent traps are issued in
relation to link status changes.
•
Integral Modules
Trap Type
ipoGenEntityFailureEvent
ipoGenEntityOperationalEvent No
• Where ipoGenEntityFailureEvent and ipoGenEntityOperationalEvent traps are issued for
voice compressor modules in relation to data access problems that result in code reload
• Other Plug-In Modules
• The ipoGenEntityChangeEvent trap is issued for changes in PC-Card slot population on
the IP Office Small Office Edition.
IPO-PHONES-MIB:
Trap type
ipoPhonesChangeEvent
Installation Manual
IP Office 3.0
Phone Digital
Station
Yes Yes
Yes
Yes Yes
Yes Yes
Quad Quad
Analog BRI
Trunks Trunks
No Yes
Yes
Modem Voice Compressor
No Yes
Yes
Generated
Upon change of a DS or IP extension phone type after normal start-
up. No traps are issued for POT extensions as the presence or
absence of such phones cannot be established hence the
ipoPhonesType for such extensions is always potPhone.
40DHB0002UKCL Issue 12c (24th February 2005)
Analog S08 WAN3
Trunk
Yes Yes No
Yes Yes No
Yes Yes No
Yes Yes No
PRI E1 PRI J1
Trunks Trunks
Yes Yes
Yes Yes
Technical Data
PRI R2 PRI T1
Trunks Trunks
Yes Yes
Yes Yes
Page 93