Ip412 Office Platform; Ip412 Office; Expansion Modules; Integral Modules (Optional) - Avaya IP Office 3.0 Installation Manual

Hide thumbs Also See for IP Office 3.0:
Table of Contents

Advertisement

IP412 Office Platform

IP412 Office

The IP412 Office base unit, running software level 3.0+, supports up to 360 extensions by using up to 12
Expansion modules. Connection to trunks is via a combination of any of the following integral interface
modules:-
Single or Dual* PRI E1/PRIE1-R2 (30 or 60 trunks respectively).
Single or Dual* PRI T1 (24 or 48 trunks respectively - USA only).
(*dual PRIs can be fitted to either Slots A or B).
Quad BRI (8 trunks) .
Analog 4 (4 loop start trunks).
Dual independent auto-negotiating 10/100 Base-TX Ethernet ports provide segmented access (allows a
firewall break to be used) to the LAN.
(Where IP telephones are to be used a suitable LAN switch with QoS capabilities, must be used.)

Expansion Modules

Optional Expansion Modules allow the IP412 Office to be expanded to a maximum of 360 digital or
analog extensions. The Expansion Modules (with the exception of the WAN3 – see below) are
connected via the Expansion Port sockets that are located on the back of each unit.
Up to twelve, in any combination, of the following Expansion Modules can be supported by the IP412
Office base unit provided that the maximum number of extensions does not exceed 360.
IP400 Digital Station 16/30
Two variants of 16 or 30 extensions for digital telephones. Hence, twelve IP400 Digital
Terminal/Station modules can be fitted to allow a maximum of 360 digital extensions.
IP400 Phone 8/16/30
Three variants (for 8, 16 or 30 extensions) for analog telephones. Hence, twelve IP400 Phone
modules can be fitted to allow a maximum of 360 analog extensions.
IP400 So8
An S-bus module that provides 8 Basic rate ISDN interfaces.
IP400 WAN3
Provides support for a further 3 digital leased line (WAN) connections. These expansion modules
are connected to the IP403 Office unit via one of the LAN Ports located on the front of each unit.
IP400 Analog Trunk 16
Provides support for up to 16 Loop Start or Ground Start analog trunks. Two power fail sockets
are also provided.

Integral Modules (Optional)

In addition the IP412 Office can be fitted with either or both of the following optional Integral Modules:
Voice Compression Module (VCM)
Provides VoIP applications (including trunking) and support for IP telephones. Available in 5, 10,
20 and 30 channel variants. The IP412 Office supports two VCMs of any type.
Modem Modules
Dual Modem Module:
Allows termination of two simultaneous analog modem calls up to and including 56kbps
(V90).
Internal Modem Module:
Allows termination of up to 12 simultaneous analog modem calls up to and including
56kbps (V90).
Installation Manual
IP Office 3.0
40DHB0002UKCL Issue 12c (24th February 2005)
IP412 Office Platform
Page 17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ip403 officeIp406 office v2Ip412 office

Table of Contents