Initial Assembly - Avaya IP Office 3.0 Installation Manual

IP Office Installation

Initial Assembly

Prior to initial assembly and mounting (rack or free standing) of your system, you must perform the
following:
• For Analog Trunk 16 expansion modules, ensure that the protective ground is fitted (see IP400
Analog Trunk 16 and Protective Ground).
• Ensure that the required Trunk Interface Modules have been installed. See:
•
IP403 Office - Rear View, P406 Office V2 - Rear View and IP412 Office - Rear View for which
trunk types can be fitted to which platforms
• Trunk Module Kits for the correct country variant type.
• Grounding if functional grounding is required
•
Trunk Interface Modules (BRI/PRI/ANALOG4) for installation instructions.
• Any optional Integral Voice Compression and/or Dual Modem Modules have been fitted (see
Installation of Voice Compression Modules (VCM) and Dual Modem Module).
• Where rack mounting is required, that the mounting brackets have been fitted (see Rack
Mounting Assembly Instructions).
•
Where structured cabling is to be used it has been installed, conforms to all local regulations and
is clearly labeled.
Perform the following:
1. Mount the IP Office modules in their final location (free standing units are ideally stacked one
upon another).
2. Run the individual Lump-in-Line PSU cables back to the switchable mains supply but do not
switch-on or connect the PSUs to the IP Office modules.
3. With the exception of a WAN3 module, connect the IP Office Control Unit to the Expansion
Modules using blue Expansion Interconnect Cables (see Expansion Interconnect Cable). These
cables run from one of the Expansion Ports on the rear of a base module to the Expansion Port
on the rear of the Expansion Modules.
For WAN3 Modules, use a LAN Interconnect Cable running between the LAN Port on the front of
the WAN3 module to one of the LAN Ports on the front of either an IP403 or IP406 unit or, via a
hub, to LAN1 Port on the front of the IP412 unit.
4. Connect the Trunk Ports on the control unit, using PRI/BRI CAT5E cables, to your provider's
trunk sockets (see PRI/BRI ISDN Cable).
5. Connect the DS/POT Ports on the front of the units, to the structured cable sockets (see Line
Cord for Structured Cabling).
6. Install all telephones in their appropriate locations (see Wall Mounting IP Office Phones).
7. Connect your PC LAN Port to one of the LAN Ports on the front of an IP Office base module
using a LAN Cable.
8. Connect the individual Lump-in-Line PSU to each IP Office module and switch on.
• IMPORTANT
Power on the Expansion Modules first. If the main IP Office Module does not detect an
item at power on, it will not use it. If power is switched on from a central point for all
modules, then, as the main unit is the slowest to start, this will be taken care of
automatically.
9. Refer to System Programming - Introduction and, from the IP Office Administrator CD, proceed
with Installing the IP Office Software Suite.
Installation Manual
IP Office 3.0 40DHB0002UKCL Issue 12c (24th February 2005)
Page 44