Recalling The Zone Bypass Scheme; Programming User Codes - Visonic PowerMaster-10 G2 User Manual

MENUS AND FUNCTIONS
B.3 Recalling the Zone Bypass Scheme
 Use this option to repeat (recall) the most recent Bypassed Scheme for use during the next arming session.
1.
RECALL BYPASS
2. <OK> TO RECALL
3.
Bypass RECALLED
☺

Return to step 1
1 For detailed instructions on how to select User Settings – refer to section B.1 and section B.2.
2
This menu is displayed only if "BYPASS" was previously enabled by the installer.
3
a. The STATUS to the right of the zone number indicates whether the zone is READY, NOT-READY or
BYPASSED.
b. In the example on the left the display reads [
4
This display will appear only in PowerMaster-30 G2 and if PARTITIONING was previously enabled.
5
a. If the zone you selected is "not bypassed", the display prompts you to press [
if the zone you selected is already "bypassed", the display prompts you to press [
b. To abort and return to the previous step press
6
This menu is not displayed if Partition is enabled.
7
The display now prompts you to press [
abort and return to the User Settings menu, press
8
You can now repeat steps 2 - 5 to bypass or clear another zone. To end this session and to select other
menu options or to quit programming - follow the instructions in section B.2.
9
You can now select another option in the User Settings menu (see section B.1), or quit programming (see
section B.2).
B.4 Programming User Codes
PowerMaster system allows you to authorize up to 8 people (PowerMaster-10 G2) / 48 people (PowerMaster-
30 G2) to arm and disarm the system by providing each with a unique 4 digit personal security code, and
assigning them with different security levels and functionalities. There are two types of users: Master User and
User. The table below summarizes the different operations that can be performed by different users:
User type Function
Arm/disarm
Master User
Zone bypass
Authorize 7 other user codes
Set user codes
Report to private
Enroll/delete proximity tag
Enroll/delete keyfob
Automatic arming
Enable squawk
Set date and time format
Read event log
Arm/disarm
User
Zone bypass options
The user codes are assigned as follows:
User Code 1 is assigned to the Master User of the system (i.e. the owner). It is the only user code that allows
access to the User Settings menu. The default setting of the Master User code is 1111. This code cannot be
22
Enter the [USER SETTINGS] menu, select the [RECALL BYPASS]
2, 6
and press .
The display now reads [<OK> TO RECALL].
To recall the last used bypass scheme press
☺
A "Happy Tune" 
sounds. The display reads [
USER SETTINGS
then returns to "
Additional Information (section B.1 – B.3)
Z01: READY
<OK> TO RECALL
7
Bypass RECALLED
9
" step 1.
Living Room
] alternating with [
<OK> TO BYPASS
<OFF> TO CLEAR
or
] i.e. to repeat the last used bypass scheme. To
.
D-303223 PowerMaster-10/30 G2 User's Guide
1
option
.
] and
].
]. However,
].