Visonic PowerMaster-10 G2 User Manual page 24

erased and must be replaced with a secret code as soon as possible.
User Codes 2-4 (PowerMaster-10 G2) / User Codes 2-22 and 33-48 (PowerMaster-30 G2) are assigned to
family members, co-workers etc. They enable arming and disarming of the system or of selected partitions as
defined by the Master User. They can access the "User Settings" menu only for "zone bypassing" provided this
option is enabled in the Installer menu.
User Codes 5-8 (PowerMaster-10 G2) / User Codes 23-32 (PowerMaster-30 G2) are the same as user
codes 2-4 / 2-22 but can be assigned to "Latchkey" (child monitor) users. For a detailed explanation of the
Latchkey application see Chapter 2 (Arming in the Latchkey Mode) and Appendix C.
*
Partition Option
Your alarm system can divide zones into up to 3 parts (groups) via the installer menu. These parts are
designated as partitions P1, P2 & P3. Each partition can be armed and disarmed separately providing
protection to selected parts of the premises.
Each user out of the 48 system users can be authorized by the Master User to arm and disarm any combination
of partitions including all 3 partitions.
 Here you can program (or edit) the 8/48 User Codes and thereby define which of these will be authorized to
arm and disarm.
1. The default setting 1111 of the Master User Code is the same for all PowerMaster systems and is

known to many other people. Therefore, we highly recommend that you immediately replace it with a
unique secret code. Never set any user code the same as any installer code.
2. Code "0000" is not valid! Do not use it.
3. The duress code (2580 by default), which is set in the installer menu, cannot be selected as a normal
user code. Any attempt to program it will be rejected by the system.
4. Carefully read the section titled "Additional Information" according to the indicated references
see table at end of this section.
A. To Program a User Code
1.
USER CODES
2.
User 01 Code
or
3.
User 06 Code
4.

User 06 :
5.
User 06 : 1234
☺

Return to step 3
B. To Set Partitions Authorization
6.
SET PARTITIONS
7.

U06:P1 P2 P3

U06:P1 P2 P3
*
Refers to PowerMaster-30 G2
†
Refers to PowerMaster-30 G2 only and after PARTITIONING is enabled.
D-303223 PowerMaster-10/30 G2 User's Guide
(For information about Partition option - see Appendix B)
Enter the [USER SETTINGS] menu, select the [USER CODES] option and
press
The first user code "User 01 Code" is displayed.

At the blinking cursor position, key in the User Code you wish to program , for
example, [06] for user code 6, or alternatively click the
button until the display reads, [User 06 Code].
When the user code you wish to program appears on the display, press

.
To program or edit the code, at the blinking cursor position enter the 4 digit
234
code, for example, "1234", using the numerical keypad.
When done, press
A "Happy Tune" 
†
The display will read [SET PARTITIONS].
Use the keypad keys
partitions P1, P2 & P3, respectively.

When you are satisfied with the setting, for example, User 6 is authorized
MENUS AND FUNCTIONS
1
.
.
☺
sounds. The display confirms the saved code.
, ,
8
2
or
3, 4
7
to change the status of the
1
etc –
5, 6
23