Reviewing The Bypassed Zone List; Recalling The Last Bypass Scheme; Programming Private Report - Visonic POWERMAXCOMPLETE User Manual

PRESS RESULTANT DISPLAY
Z22: BYPASSED
LIVING ROOM
<OFF> TO CLEAR
Z22: FUNCTIONAL
LIVING ROOM
You may now click
item on the USER SETTINGS menu, or click
to quit programming. When <OK> TO EXIT appears
- click .

Reviewing the Bypassed Zone List

Having entered your user code successfully (see
above - Entering to the User Settings Menu), the
display will read:
SET BYPASS
Click to change the display into:
SHOW BYPASS
Click to change the display into:
BYPASS LIST
If at this point you click
state and name of the first bypassed zone will be
displayed.
You can now click
all bypassed zones, in ascending numerical order.
When done, clicking
SHOW BYPASS and clicking
to <OK> TO EXIT.

Recalling the Last Bypass Scheme

Arming the alarm system with several zones in the
bypassed state is in fact "partial arming". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
Having entered your user code successfully (see
above - Entering to the User Settings Menu), the
display will read:
SET BYPASS
Click twice to change the display into:
RECALL BYPASS
At this point proceed as follows:
D-302755
(alternating)
(alternating)
and then select any other
, the number,
repeatedly to review
will get you back to
will get you back
USER SETTINGS
ACTION
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
.

Programming Private Report

Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
button repeatedly (if necessary) until the
display will read:
REPORT TO PRVT
Report to Private
Here you determine the event groups to be reported –
"disable report", "all", "all (-op/cl)" (all messages,
except open/close), all (–alerts) (all messages, except
alerts), "alarms", "alerts", "op/cl" (open/close).
Private Telephone Numbers
Here you determine the 1st, 2nd, 3rd and 4th
telephone numbers to which the system will report
event messages that were defined by the system
installer.
Redial Attempts
Determining the number of times the called party's
private telephone number is dialed (1, 2, 3, or 4
attempts).
Voice Private
Here you determine whether or not 2-way voice
communication with private telephones will be allowed.
Telephone Acknowledgement
Here you determine whether to use a single
acknowledge signal, or, an acknowledge signal from
each telephone before the current event is
considered reported.
SMS Messages
Here you determine the 1st, 2nd, 3rd and 4th SMS
telephone numbers to which pre-selected event
types will be reported.
Perform the above mentioned settings according to
Figure 8 (Private Report) menu. These settings may
be performed by the installer, if desired.
You may now switch to any other item on the USER
SETTINGS menu or quit programming by clicking
until <OK> TO EXIT is displayed and
then clicking
RESULTANT DISPLAY
<
OK> TO RECALL
RECALL BYPASS
.
25