B3. The Show Function; B4. Siren; B5. Partition Status Display - Visonic PowerMaster-10 G2 User Manual

Arming/Disarming a Single Partition
To arm/disarm a single partition, press the
number: 1; 2; or 3. Then, press the

B3. The Show Function

The show function is enabled during single/all partition(s) status and displays information that is relevant to the
selected or all partitions.
Show All Partitions
In Ready mode press
repeatedly to view memory / status content.
Show Single Partition
In Ready mode, press
the selected partition. Press
Note: After 5 seconds of no button press there will be a timeout and the display will revert to the all partition
display.

B4. Siren

A partition is alarmed when receiving an event from an alarmed device assigned to that partition. Alarmed
devices do not affect partitions to which they are not assigned. A siren is common to all partitions; therefore, an
alarm from one or more partitions will activate the siren.
Siren Activity

The siren will be activated when receiving an event from an alarmed device.

Overlapping siren activations from different partitions will not cause the duration of the siren to be
extended.

When the siren sounds, it will not stop until all alarmed partitions are disarmed. However if the siren is
active due to an alarm from a common area zone, and one of the partitions assigned to this area disarms
the system, the siren will also stop. In case that the alarm is initiated from a common area but continues
with zones that are not assigned to a common area, the siren will not stop until all partitions assigned to
the alarmed zones are disarmed.

In case that there is a fire in partition 1 and a burglary in partition 2, the siren will sound FIRE. When
partition 1 is disarmed, the siren will sound BURGLAR for the remainder of the siren timeout period.

B5. Partition Status display

Partitions status is indicated in the following manner:
P1:X P2:X P3:X
Each X value indicates a different partition state, as follows:
R Ready
N Not ready
A Away
H Home
E Exit delay
D Entry delay
- Not used
D-303223 PowerMaster-10/30 G2 User's Guide
button on the control panel and then press the Partition
/ or
, the display will show information on all partitions. Press
and then press the partition number. The display will show information relevant to
repeatedly to view memory / status content.
button.
APPENDICES
51