Recalling The Last Bypass Scheme; Programming Private Report; Setting The User Codes - Visonic POWERMAXPRO User Manual

USER SETTINGS
PRESS RESULTANT DISPLAY
Enter user code SET BYPASS
SHOW BYPASS
BYPASS LIST
If at this point you click
and name of the first bypassed zone will be
displayed.
You can now click
all bypassed zones, in ascending numerical order.
When done, clicking
SHOW BYPASS and clicking
back to <OK> TO EXIT.

Recalling the Last Bypass Scheme

Arming the alarm system with several zones in the
bypassed state is in fact "partial arming". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
Having entered your user code successfully (see
above - Entering to the User Settings Menu), the
display will read:
PRESS
Enter user code
At this point proceed as follows:
PRESS
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
.

Programming Private Report

Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
button repeatedly (if necessary) until the
display will read:
REPORT TO PRVT
28
, the number, state
repeatedly to review
will get you back to
will get you
RESULTANT DISPLAY
SET BYPASS
RECALL BYPASS
RESULTANT DISPLAY
<
OK> TO RECALL
RECALL BYPASS
Report to Private
Here you determine the event groups to be reported
– "disable report", "all", "all (-op/cl)" (all messages,
except open/close), all (–alerts) (all messages,
except alerts), "alarms",
(open/close).
Private Telephone Numbers
Here you determine the 1st, 2nd, 3rd and 4th
telephone numbers to which the system will report
event messages that were defined by the system
installer.
Redial Attempts
Determining the number of times the called party's
private telephone number is dialed (1, 2, 3, or 4
attempts).
Voice Private
Here you determine whether or not 2-way voice
communication with private telephones will be
allowed.
Telephone Acknowledgement
Here you determine whether to use a single
acknowledge signal, or, an acknowledge signal from
each telephone before the current event is
considered reported.
SMS Messages
Here you determine the 1st, 2nd, 3rd and 4th SMS
telephone numbers to which pre-selected event
types will be reported.
Perform the above mentioned settings according to
Figure 8 (Private Report) menu. These settings may
be performed by the installer, if desired.
You may now switch to any other item on the USER
SETTINGS menu or quit programming by clicking
until <OK> TO EXIT is displayed and
then clicking

Setting the User Codes

Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
until the display reads:
SET USER CODES
User Code 1 replaces the factory default master
user code, and should be assigned to the master
user of the system. This code can not be erased.
User Codes 2, 3 and 4 can be assigned to additional
users - family members, co-workers etc.
Codes 5 through 8 are assigned to "Latchkey
Users" (see Chapter 2 - Arming in the Latchkey
Mode, for an explanation of the latchkey mode).
Caution! Code "0000" is not valid! Do not use it.
"alerts", "op/cl"
.
D-302542