Disarming Under Duress; Partition Selection Process; Special Arming & Disarming Options; Switching From 'Home' To 'Away - Visonic PowerMaster-10 G2 User Manual

OPERATING THE POWERMASTER SYSTEM

Disarming under Duress

If you are forcibly compelled to disarm the system, enter the duress code (2580 by default) or another code set
by the installer. Disarming will take place normally but a silent alarm will be transmitted to the monitoring station.

Partition Selection Process

Access to any desired partition is achieved through the use of an individual code or proximity tag. It is not
possible to access the INSTALLER MENU if one or more partitions are in the AWAY or HOME modes.
Before attempting to perform any operation on any given partition(s), it is necessary to perform the operations
below which enable you to select the desired/allowed partition(s) using the individual code or proximity tag:
PRESS
Enter partition # (1 - 3)
Note: The "Sad Tune" will be heard when selecting a partition to which no sensors / peripherals were enrolled.
Special Arming & Disarming Options
In addition to basic arming, PowerMaster provides you with several advanced arming and disarming options:

Switching from 'HOME' to 'AWAY'

You do not have to disarm the system - just press
AWAY above. Vacate the premises before the exit delay expires.

Switching from 'AWAY' to 'HOME'

You do not have to disarm the system - just press
Master will ask you to key in your master user code or user code, thus making sure that you are an authorized user.
PRESS
[Enter code]
Move to interior zone
ARM indicator flashes during the armed state.

Arming AWAY or HOME 'Instant'

Pressing during the exit delay will arm the system in the "Instant' mode, i.e. without an entry delay.
Therefore, any detection in any zone will trigger an immediate alarm. To arm AWAY-INSTANT, proceed as follows.
PRESS
Vacate the premises
ARM indicator lights during the armed state.

Forced Arming AWAY or HOME

Forced arming allows you to arm the system even if the system is "NOT READY". Any open zones will be
bypassed for the duration of arming.
10
RESULTING DISPLAY
SELECT PARTITION
PARTITION 1
RESULTING DISPLAY
ENTER CODE _ _ _ _
Code
ARMING HOME
 (Exit delay) 
ARM HOME HH:MM
RESULTING DISPLAY
ENTER CODE _ _ _ _
Code
ARMING AWAY
ARMING INSTANT
(alternating)
PLEASE EXIT NOW
 (Exit delay) 
AWAY
. The response will be the same as in ARMING
. Since this operation reduces the security level, Power-
D-303223 PowerMaster-10/30 G2 User's Guide