Recalling The Last Bypass Scheme; Programming 4 Telephone Numbers; Setting The User Codes - Visonic PowerMax Complete User Manual

Recalling the Last Bypass Scheme

Arming the alarm system with several zones in the
bypassed state is in fact "partial arming". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
Having entered your user code successfully (see
above - Entering to the User Settings Menu), the
display will read:
SET BYPASS
Click twice to change the display into:
RECALL BYPASS
At this point proceed as follows:
ACTION
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
.

Programming 4 Telephone Numbers

Here you determine the 1
numbers to which the system will report event
messages that were defined by the system installer
or master user. You can ask the installer to set part
or all the four telephone numbers.
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
button repeatedly (if necessary) until
the display will read:
SET PHONE NUMBER
You are allowed to program the 4 numbers as follows:
PRESS RESULTANT DISPLAY
1st private tel#
XXXXXXXXX
[Enter Tel. No.] XXXXXXXXX
XXXXXXXXX
1st private tel#
2nd private tel#
D-302213
RESULTANT DISPLAY
<
OK> TO RECALL
RECALL BYPASS
st nd rd th
, 2 , 3 and 4 telephone
USER SETTINGS
Continue the same way up to telephone number 4.
You may now switch to any other item on the USER
SETTINGS menu or quit programming by clicking
until <OK> TO EXIT is displayed and
then clicking

Setting the User Codes

A maximum of eight 4-digit codes can be defined out
4
of a total of (10) = 10000 user code possibilities.
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
until the display reads:
SET USER CODES
User Code 1 replaces the factory default master
user code, and should be assigned to the master
user of the system. This code can not be erased.
User Codes 2, 3 and 4 can be assigned to additional
users - family members, co-workers etc.
Codes 5 through 8 are assigned to "Latchkey
Users" (see Chapter 2 - Arming in the Latchkey
Mode, for an explanation of the latchkey mode).
CAUTION! Code "0000" is not valid! Do not use it.
Note: The duress code set by the installer (2580 by
default) cannot be selected as a normal user code.
Any attempt to program it will be rejected by the
PowerMaxComplete.
To program the codes, proceed as follows:
PRESS
[4-digit
user code]
e.g. 6854)
[4-digit
user code]
e.g. 9854)
To reset the user code, set the user
code to 0000.
In PowerMaxComplete Partition systems
.
RESULTANT DISPLAY
user code 1: _ _ _ _
user code1: 1 1 1 1
user code 1: 6854
user code 1: 6854
user code 2
user code 2: 1 1 1 1
access to part
25