Reading The Event Log; Exiting The Event Log - Visonic PowerMaster-10 G2 User Manual

Reading the Event Log

To read the event log, proceed as follows:
READY 00:00
1.
ENTER CODE: _
2. CODE
LIST OF EVENTS
3.
Z13 alarm
09/02/10 3:37 P
4.

Exiting the Event Log

or
1.
<OK> TO EXIT
2.
READY 00:00
D-303223 PowerMaster-10/30 G2 User's Guide
When the PowerMaster display reads [ENTER CODE: _], enter the current
master user code.
The "Happy Tune" will sound and the PowerMaster display will read [LIST
OF EVENTS]. (see Important Note!)
Click the button. The latest event will be shown.
The event is displayed in two parts, for example, "Z13 alarm" then
"09/02/10 3:37 P".
The two displays will be shown alternately until clicking
move to the next event or until the event log times out (4 minutes).
Click the button as many times as necessary to read all the
required data.
Important Note! Entering an incorrect code 5 times in a row will initiate a
30-second penalty lockout of the keypad.
Attention: The system will not allow you to erase the event log. Only the
installer is authorized to view and perform this function.
Click the or
The PowerMaster display will read [<OK> TO EXIT].
Click the button.
The system reverts to the normal operating mode.
MAINTENANCE
button from anywhere within the event log.
again to
47