Setting The Message Types For Notification; Setting The Type Of Notification - Altigen MAXCS ACC 6.0 Administration Manual

Chapter 22: Workgroup Configuration
You can use Apply to to apply mailbox settings to one, some, or all workgroups.
Note:
See "Apply to Button" on page 267 for more information on using Apply to.

Setting the Message Types for Notification

Select the types of messages for which the workgroup user will be notified:
None—selected, the user is not notified with a call regarding newly received
•
messages. Selecting this option does not prevent the user from getting message
waiting indicators or stutter dial tone when new messages are received.
Urgent Voice Messages Only
•
All Voice Messages
•
Please note that the system will start notification as soon as it enters non-business hours
under the following conditions:
Extension is set to notify Urgent Voice Message Only
•
Notification is set to Non-Business Hours
•
Voice mail is received during business hours and is marked urgent
•
Extension user does not check the urgent message
•

Setting the Type of Notification

There are three options for sending the notification or reminder message: phone,
pager, or extension.
Extension—to use the Extension option, select the Extension radio button, then
•
type the extension number into the text box.
Phone/Pager—for the Phone and Pager options, first specify the trunk or route
•
access code using the drop-down list next to the Phone radio button. The Any
option means to locate any available trunk. Then type in the number with all relevant
dialing prefixes other than the trunk code, using a maximum of 63 digits.
Note also the following considerations:
For the Pager option, the system calls the specified pager number and then dials
•
the system main number (as set in System Configuration, General tab), which is
then displayed on the user's pager.
For the operator-assisted paging function, the operator phone number and the
pager number must be entered in the <phone number>*<pager number>
format. For example, if the phone number to call the pager operator is 7654321
and the pager number to page the user is 12345678, the notification outcall
number that needs to be entered is 7654321*12345678. When the pager operator
answers the Message Notification call, MAXCS announces the pager number and
the System Main Number (as configured on the General tab of System
Configuration), which will be displayed on the user's pager. The operator is also
given the option to repeat these numbers by pressing '#'.
276
MAXCS ACC 6.0 Administration Manual