Altigen MAXCS ACC 6.0 Administration Manual page 244

Chapter 17: AltiGen IP Phone Configuration
Display
Workgroup
Status
The configuration in MaxAdmin will override the IP phone's local configuration
Important:
after the IP phone is registered. If the IP phone's local configuration is
changed while in Basic mode, these changes will be overwritten by MaxAdmin
settings.
Administrators should perform any updates to the IP phone's firmware after
Important:
normal business hours or when the IP phone is not in use. If the IP phone is
in use during an update, not only will the call will be disconnected, but if the
IP phone is powered off by the user during the firmware upgrade, the IP
phone may become unusable.
Apply To Button
The Apply To button works with the following parameters: General, TFTP Server field
(Reset IP Phone and Boot Download options cannot be applied to multiple
extensions), Debug, and Display Workgroup Status (IP 705 and IP 600).
Copy From Button
The Copy From button allows you to copy Programmable Key settings from one IP
phone extension to another. No other settings are carried over.
230
MAXCS ACC 6.0 Administration Manual
—
• Headset (Alti-IP 600, IP 705) When configured from the
drop-down list for programmable key 10 (Alti-IP 600) or
programmable key 5 (IP 705), the IP phone user will be able
to activate a third-party headset (certified by AltiGen).
—
• Flash (Alti-IP 600) Upon initial installation, the lower left
programmable key is set up as FLASH by default. This key
can be re-assigned in MaxAdmin, using the AltiGen IP Phone
Configuration window. No other programmable keys can be
configured to FLASH.
(Alti-IP 600 and IP 705) When enabled, allows the IP phone to
display workgroup queue status, such as number of queued
calls, the current longest queue time, agent login/logout state
by pressing the Down arrow key.