Ir Transmission Delay; Ur2 Duplex Mode; Onboard Parallel Port; Parallel Port Mode - Albatron PM800 Series User Manual

IR Transmission Delay

This item allows you to enable/ disable IR transmission delay. This field only configurable if "UART
Mode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabled

UR2 Duplex Mode

Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".

Onboard Parallel Port

This item allows you to determine the parallel port interrupt and address.
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled

Parallel Port Mode

This option allows you to select an operating mode for the on board parallel port.
Options: ECP(default)
EPP
SPP
ECP+EPP
Normal

EPP Mode Select

Select EPP port type 1.7 or 1.9. Options: EPP 1.7、EPP1.9 (default)

ECP Mode Use DMA

Select a DMA Channel for the port. Options: 3 (default)、1
Game Port Address
Game Port I/O Address. Options: 201 (default)、209、Disabled
Midi Port Address
Midi Port Base I/O Address. Options: 330 (default)、300、290、Disabled
Midi Port IRQ
This determines the IRQ that Midi Port will use. Options: 5 (default)、7
Extended Capabilities Port.
Enhanced Parallel Port.
Standard Printer Port.
ECP & EPP mode.
36
PM800 Series