Ir Transmission Delay; Ur2 Duplex Mode; Use Ir Pins; Onboard Parallel Port - Albatron KM18G PRO II User Manual

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field only configurable if "UART
M ode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabled

UR2 Duplex Mode

Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
Options: Half (default)、Full

Use IR Pins

Consult your IR peripheral documentation to select the correct setting of the TxD and RxD signals.
This field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
O ptions: Full、Half (default)

Onboard Parallel Port

Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)、278/IRQ5、

Parallel Port Mode

This option allows you to select a parallel port mode for the onboard parallel port.
Options: ECP(default)
EPP
SPP
ECP+EPP
Normal
EPP Mode S elect
S elect EPP port type 1.7 or 1.9. This field is only configurable if "Parallel Port Mode" is set to "EPP"
or "ECP+EPP". Options: EPP 1

ECP Mode Use DMA

S elect a DMA Channel for the parallel port when using the ECP mode. This field is only
configurable if "Parallel Po
3BC/IRQ7、Disabled
Extended Capabilities Port.
Enhanced Parallel Port.
Standard Printer Port.
ECP & EPP mod e.
.9(default)、EPP 1.7
rt Mode" is set to "ECP". Options: 3 (default)、1
35
KM18G PRO/ KM18G PRO II