Table of Contents
Advertisement
PM800 Series
"NO", BIOS will initialize all the PnP cards. For non-PnP operating systems (DOS, Netware), this option
must be set to "NO".
Options: No (default)、Yes
Reset Configuration Data
Select "Enabled" to reset the Extended System Configuration Data (ESCD) if you have installed a new
add-on card and the system reconfiguration has caused such a serious conflict that the OS cannot boot.
Options: Disabled (default)、Enabled
Resources Controlled By
BIOS can automatically configure all the boot and Plug and Play compatible devices. If you choose Auto,
you will not be able to manually assign IRQ DMA and memory base address fields, since BIOS
automatically assigns them. Options: Auto <ESCD> (default)、Manual
IRQ Resources
When resources are controlled manually, you can assign each system interrupt a type, depending on
the type of device using the interrupt. This is only configurable when "Resources Controlled By" is set
to "Manual".
IRQ-3/4/5/7/9/10/11/12/14/15
assigned to: PCI device
PCI / VGA Palette Snoop
Some graphic controllers that are not VGA compatible take the output from a VGA controller and map
it to their display as a way to provide boot information and VGA compatibility. Options: Disabled
(default)、Enabled
PCI Latency Timer (CLK)
This item allows you to set up the PCI Latency Time (0-255). If you select the "32" it will optimize PCI
speeds. Options: 0-255、32 (default)
PCI1-3 IRQ Assignment
This item allows you to select an IRQ address for your PCI slot 1-3.
Options: Auto (default)、3、4、5、7、9、10、11、12、14、15
Frequency/Voltage Control
CPU Clock Ratio
This field will only display if the CPU has not been set to a locked state by the CPU manufactory. If your
CPU is locked, you will not be able to adjust the "CPU Clock Ratio". Options: depends on CPU.
Spread Spectrum
The Spread Spectrum function can reduce the EMI (Electromagnetic Interference) generated.
Options: Enabled (default)、Disabled
31
Hide quick links:
Advertisement
Chapters
Table of Contents
