Ir Transmission Delay; Ur2 Duplex Mode; Onboard Parallel Port; Parallel Port Mode - Albatron PX915PC PRO-G User Manual

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field only configurable if "UART
Mode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabled

UR2 Duplex Mode

Select the transmission mode used by the IR interface. Full-duplex mode
bi-directional transmission. Half-duplex mode permits transmission in only one direction
T his field only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA". Options: Half
(default)、Full
Use IR Pins
Consult your IR peripheral documentation to
field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
Options: RxD2、DxD2 (de fault)

Onboard Parallel Port

Select an address and correspond
Options: 378/IRQ7 (default)、278/IRQ5

Parallel Port Mode

This option allow s you to select a parallel port mode for the onboard parallel port.
Op tions:
ECP (default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode
N ormal

EPP Mode Select

Select EPP port type 1.7 or 1.9. This field is only configurable if
" ECP+EPP". Options: EPP 1.9(default)、EPP 1.7
E CP Mode Use DMA
Se lect a DMA Channel for the parallel port when using the ECP mode. This field is only configurable if
" Parallel Port Mode" is set to "ECP". Options: 3 (default)、1
PX915PC/ PX915GC Series
select the correct setting of the TxD and RxD signals. This
ing interrupt for the onboard parallel port.
、3BC/IRQ7、Disabled
.
37
permits simultaneous
"Parallel Port Mode" is set to "EPP" or
at a time.