Hot Key Power On; Onboard Fdc Controller; Ir Transmission Delay; Ur2 Duplex Mode - Albatron PX865PEL-800 Instruction Manual

Hot Key Power ON

This option allows you to use the Ctrl key along with a hot key (function key) to power on your
system. This filed is only configurable when "Power On Function" is set to "Hot Key".
Options: Ctrl-F1、Ctrl-F2 ...... Ctrl-F12

Onboard FDC Controller

Select "Enabled" if your system has a flo
y ou wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled".
Options: Enabled (default)、D
Onboard Serial Port 1/ Port 2
Select an address and corresponding int
Options: Disabled、3F8/IRQ4 (defa
2E8/IRQ3、Auto
UART Mode S elect
This item allows you to select the Infra Red (IR) standard to be used.
、
O ptions: Normal (default) ASKIR IrDA
RxD, TxD Active
This item determines the RxD and Tx
Select" is set to "ASKIR" or "IrDA".
Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field only configurable if "UART
Mode Select" is set to "ASKIR" or "IrDA".
Options: Enabled (default)、Disabled

UR2 Duplex Mode

Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneo
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
O ptions: Half (default)、Full
ppy disk controller (FDC) installed on the system board and
isabled
errupt for the first/ second serial port.
ult for port1)、2F8/IRQ3(default for port2)、3E8/IRQ4、
、
D frequencies. This field only
Lo / Lo
32
PX865PEL-800
configurable if "UART Mode
us