Albatron PM800 Series User Manual page 57

1. The "Create Array" option will allow you to initialize a RAID array. Choose the "Create Array" on
the main screen and press <Enter>. The screen below will display. According to your needs, select
"RAID 0 for performance" (striping), "RAID 1 for data protection" (mirroring) or "RAID SPAN for
capacity" (JBOD). Then press <Enter>.
Attention
The "Channel"、"Drive Name"、"Mode"、"Size (GB)", located at the
bottom portion of the screen above, reflect the devices that are currently
installed on the SATA connectors. The example information above may
therefore differ with the information that displays on your screen.
2. Next, choose the "Auto Setup for Data Security" option and press <Enter>. The screen will display
a c onfirmation message as shown below. Press <Y> to continue with the creation of the new array.
Attention
For RAID 1 (Mirrored Arrays), you can manually select the "source
device" instead of having the system determine it for you. After step 1,
select the "Select Disk Drives" to manually select the "source device".
Then choose the "Start Create Process" and press <Enter> to complete
the RAID 1 array creation.
3. After the array has been successfully created, one of the screens will display as shown below
according to the type of array you created.
53
PM800 Series