Onboard Fdc Controller; Uart Mode Select; Ir Transmission Delay; Use Ir Pins - Albatron PX865PE PRO II User Manual

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the sy
y ou wish to use it. If you install an add-in FDC or the system has no floppy drive, select "Disabled".
Options: Enabled (default)、Disabled
Onboard Serial Port 1/ Port 2
Select an address and correspondin
Options: Disabled、3F8/IRQ4 (d
2E8/IRQ3、Auto

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
O ptions: Normal (default)、ASKIR、IrDA
RxD, TxD Active
T his item determines the RxD and TxD frequencies. This field is only configurable if "UART Mode
Select" is set to "ASKIR" or "IrDA". Options

IR Transmission Delay

This item allows you to enable/disable IR transmission delay. This field is only configurable if
"UART Mode Select" is set to "ASKIR" or "IrDA". Options: Enabled (default)、Disabl
U R2 Duplex Mode
Select the transmission mode
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
ptions: Half (default)、Full
O

Use IR Pins

Consult your IR peripheral documentation to select the correct s
T his field is only configurable if "UART Mode Select" is set to "ASKIR" or "IrDA".
Options: Full、Half (default)

Onboard Parallel Port

Select an address and corresponding interr
O ptions: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled
g interrupt for the first/ second serial port.
efault for port1)、2F8/IRQ3(default for port2)、3E8/IRQ4、
: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo
used by the IR interface. Full-duplex mode permits simultaneous
upt for the onboard parallel port.
38
PX865PE PRO II
stem board and
ed
etting of the TxD and RxD signals.